How to Clean High Gutters

Co-authored by Allen Lee

Last Updated: September 16, 2022 References

Leaves and other debris clogging your gutters can result in damage to your home’s woodwork. In the winter, trapped water will freeze and expand in gutters, possibly ruining them. Clean your gutters at least once a year unless you have overhanging trees, in which case you’ll need a twice-a-year cleaning.^{[1]
X
Research source} To clean high gutters with a ladder, you’ll need to ensure the ladder is stable and then methodically clear the gutter by hand. To clean gutters from the safety of the ground, make a homemade gutter vacuum using a wet/dry vacuum, then pass the gutter vacuum over the gutter to remove debris.

Method 1

Method 1 of 4:

Prepping to Safely Clean High Gutters with a Ladder

1
Put on work clothes and rubber gloves. Cleaning gutters can be dirty work. Additionally, gutters can be quite sharp. For these reasons, wear work clothes that you won’t mind getting stained and durable rubber gloves.
- Even in hot weather, wear a long sleeve shirt while cleaning. This will provide additional protection from insects and from the sharp edges of gutters.^{[2]
  X
  Research source}
- When cleaning gutters on dry days, especially in dusty areas, wear eye protection and a face mask to prevent dust and pollen from aggravating your eyes and lungs.
2
Set up the ladder. Position the ladder where you plan to begin cleaning. Lean the ladder against the wall of your house, if possible. Otherwise, lean the ladder on the gutter where it is attached to the house with a fastener, like a nail. Be sure the ladder is at the correct angle, especially if you’re using an extension ladder.^{[3]
X
Expert Source

Allen Lee
Home Improvement Specialist
Expert Interview. 10 July 2020.}
- Put your toes against the feet of the ladder and extend your arms out straight. The ladder is in the proper position when your palms can comfortably reach the rungs.
- Before climbing your ladder, test it for stability by carefully climbing a step or two. If the ladder leans or wobbles, reposition it until it is sturdy.
- If the ground is soft, the ladder may dangerously sink. Place same-sized pieces of scrap wood under the feet of your ladder to prevent sinking, then test the ladder again for stability. Reposition the ladder as needed.
- Uneven or sloping ground may cause your ladder to lean.^{[4]
  X
  Expert Source
  
  Allen Lee
  Home Improvement Specialist
  Expert Interview. 10 July 2020.} Level out the ladder by putting pieces of scrap wood underneath the leg on the leaning side of the ladder. Test the ladder for stability and make any necessary adjustments.
Advertisement
3
Attach a bucket to your ladder for debris disposal. Straighten the body of a wire coat hanger but leave the hooked end as is. This should form a straight piece of metal ending in a hook. Bend the hook-opposite end around the handle of your bucket. Hang the bucket from the second rung from the top.
- Most of the debris in your gutters will be biodegradable. Should you desire to do so, debris can be thrown on the ground and left to decompose or composted.
- If more convenient, place a large garbage can, tarp, or wheelbarrow beside your ladder. Throw cleared debris in/on these receptacles.
- A plastic bag will work in a pinch as a substitute, but these can be awkward and dangerous to manage, especially if there is wind.

Method 2

Method 2 of 4:

Removing Debris from High Gutters with a Ladder

1
Remove debris from the gutter by hand or with an air compressor. Scoop buildup and debris from your gutters with your gloved hand or blow it out using the nozzle on an air compressor. Alternatively, use a tool to clean the gutters, like a garden trowel, hand spade, or plastic spatula. Do not reach for debris. Only remove debris from areas comfortably within your reach.^{[5]
X
Research source}
- For the safest gutter cleaning, have a friend or relative hold the ladder for you while you work to provide additional stability.
- Over reaching while on a ladder could compromise its stability and cause it to fall, potentially causing a serious injury.
2
Reposition the ladder and continue removing debris. When a section is clear of debris, descend the ladder and move it so you can reach the neighboring section of gutter. Clear the gutter as described. Continue repositioning and cleaning until your gutters are completely clean.^{[6]
X
Research source}
3
Flush your gutters with water. Fasten a garden hose to a pole, tree trimmer, or a sturdy branch. Attach a nozzle, turn on the hose, and raise it to the gutter. In this fashion, flush the entire gutter to finish your cleaning. Note downspouts that flow unevenly or weakly; these may still have blockages.^{[7]
X
Research source}
- If you suspect a downspout blockage, set up your ladder beside the spout. Tap along its length with a screwdriver from the top down. A dull thudding sound usually indicates a blockage.
- Downspouts can also be unfastened from the house and gutter. Lay the spout on the ground and clear blockages with a long stick, leaf blower, or pressure washer.^{[8]
  X
  Research source}

Method 3

Method 3 of 4:

Making a Homemade Gutter Vacuum

1
Equip your vacuum with a rigid extension attachment. Only use vacuums that can handle wet and dry materials, like a chipper vacuum or a wet/dry shop vacuum. Position the vacuum where you plan to start cleaning your gutters. Insert the longest hose into the vacuum and fasten the longest rigid extension attachment to the hose.
- The power cord for your vacuum may not be long enough to reach a power outlet. Use an extension cord to supply your vacuum with power in these cases.
- Choose a vacuum that has a strong motor for this project. Vacuums with weak suction will not be as effective.^{[9]
  X
  Research source}
2
Calculate the measurement of the secondary extension. Measure the total length of the rigid extension attachment. When measuring gutter height, measure from the top of the gutter to about knee height. Subtract the attachment length from the gutter height. This measurement is the total length of your secondary extension.
- While using the gutter vacuum, you’ll likely hold the attachment at about chest height. Measuring the gutter from its top to the ground will likely result in a gutter vacuum that is longer than necessary, making it more unwieldy.
3
Cut a rigid plastic tube or pipe with a hack saw. Mark the secondary extension measurement (gutter height – attachment length) on the rigid plastic tube or pipe. Use a hacksaw to cut the plastic to secondary extension length. Excess tube/pipe can be reused or thrown away.
- Cutting your tube/pipe may have left behind burrs. These can cause slivers or cuts. Remove burrs with a file when necessary.
4
Assemble the gutter vacuum.^{[10]
X
Research source} Slide the end of the extension attachment into the secondary extension. Join these pieces together firmly with aluminum tape. Do the same at the opposite end of the secondary extension with a duct elbow. When the first elbow is in place, similarly add the second elbow to it.
- Putting these pieces together will result in a long, straight, rigid extension that ends in a hook. The hook formed by the elbows should curve so it is facing roughly downwards.
- So the tool fits inside the gutter, use a nozzle or flatten the end piece.
- Be sure to tape the connections of your homemade gutter vacuum thoroughly. Gaps may cause suction to decrease, making the vacuum less effective.

Method 4

Method 4 of 4:

Using a Homemade Gutter Vacuum

1
Clean the gutters. Hold your gutter vacuum at roughly the base of the extension attachment. Switch on your vacuum. Pass the downward-facing end of the hook slowly over the gutter to remove leaves, twigs, and other debris.^{[11]
X
Research source}
- If your gutters are especially clogged, you may need to empty your vacuum while cleaning. Overly full vacuums may have decreased suction and leave behind gutter buildup.
2
Inspect the gutters for missed debris. Although most of the buildup will likely be gone after vacuuming, stubborn blockages may remain. Lean a suitable ladder against your home and climb it to visually inspect the gutters. Dismount the ladder, then target remaining clogs with your gutter vacuum.
- Some obstructions may still remain even after being targeted with your gutter vacuum. Use a tree trimmer, pole, or a sturdy stick to poke at and loosen these obstructions. Suck up loosened material with your vacuum.^{[12]
  X
  Research source}
3
Remove small bits of remaining debris and check downspout flow. Tie a garden hose to a pole or long stick. Turn on the hose and lift it up to the gutter. Rinse the entire gutter with water to remove any small debris remaining. Poor water flow at the downspout may indicate a blockage in the spout.^{[13]
X
Research source}
- Clogs can be removed from downspouts with a plumbing snake. Use the snake in the same fashion you would to remove a clogged drain.

Expert Q&A
Did you know you can get expert answers for this article? Unlock expert answers by supporting wikiHow

Question

Can I use an A-frame ladder to clean my gutters?

Allen Lee
Home Improvement Specialist
Allen Lee is a Home Improvement Specialist and the Owner of Honest Lee Handyman Services, a licensed and insured handyman business servicing Sacramento, California, and surrounding areas. Working with homeowners and businesses to get their small repairs done in a timely and efficient manner, Honest Lee Handyman Services provides gutter and dryer vent cleaning along with fixture, fence, drywall, and toilet repairs.

Allen Lee

Home Improvement Specialist

Expert Answer

Support wikiHow by unlocking this expert answer.

If it's tall enough for you to easily reach the gutters, then yes! Just make sure it's fully extended and on level ground before climbing up.

Warnings

Gutters are often very sharp. To prevent cuts, always clean gutters in a long sleeve shirt while wearing sturdy rubber gloves.

⧼thumbs_response⧽
Helpful 4 Not Helpful 0
Beware of power lines above your home. Be sure you know where they are and avoid touching them with your body or with a ladder or other tools.

⧼thumbs_response⧽
Helpful 1 Not Helpful 1