X
wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, 32 people, some anonymous, worked to edit and improve it over time.
This article has been viewed 107,269 times.
Learn more...
This is how to make a cool airsoft gun out of a Nerf gun. Note: the bigger the gun the better; a pump Nerf gun gives you more fps (feet per sec).
Steps
-
1Get a Nerf gun; any will do.
-
2Get a Nerf Dart (the ammo for Nerf gun) and pull the end off of it. You will have a foam tube.Advertisement
-
3Get a Bic pen and use pliers to take out the back and front so you have a tube.
-
4Stick the Bic pen tube into the foam tube; nearly half of the pen should be covered by the dart.
-
5Place the dart end into the barrel, push down on the dart as far as you can, then push the pen tube into the barrel.
-
6Cock and shoot nothing a few times to ensure that it doesn't fall out.
-
7Cock and shoot at your hand, if air pressure is present, good job!
Advertisement
Community Q&A
-
QuestionDoes this work with any Nerf gun?TaterBoiCommunity AnswerYes, this method will work for any front-loading Nerf blasters.
-
QuestionWill a copper BB work?Community AnswerIt may, but it is a little smaller than the Airsoft BB. If it doesn't work, you could try using a smaller pen tube.
-
QuestionHow can I do this with a Sharpfire?Community AnswerYou cannot, unfortunately. The Sharpfire is impossible to modify in this way.
Advertisement
Things You'll Need
- Nerf gun (any)
- Pen medium
- Tape (any)
- Ammo (anything that fits well in the pen tube)
About This Article
Advertisement