So you've experimented with making bracelets with loom bands and making bracelets with beads; now you want to bring the two together to make loom band with beads. Follow these steps to learn how to make loom bands with beads.

Steps

  1. 1
    Get your materials together. You will need:
    • Loom bands- it's easiest to use one colour at first.
    • Beads- if you have a bead kit it's perfect, but you just need some beads with a hole big enough to fit a piece of string through.
    • String- coloured is best, the best is the string you get in a bead kit. Make sure that it is long enough to fit around your wrist.
    • Your fingers.
  2. 2
    Start stringing your loom bands as you would in a fishtail loom. Start by putting one band in a figure of 8 position on your middle finger and index finger. Then put another band normally on your middle finger and index finger above the first band.[1]
    Advertisement
  3. 3
    Put an 'S' clip on the figure of 8 band. Then take your string, thread it through the second band and tie it on to the figure of 8 band.
    • Next, hook the figure of 8 band on to the second band, like you would in a fishtail band.
  4. 4
    Take a third loom band and place it on your middle finger and index finger. Thread the string through the middle of this band. Then take a bead and slide it to the bottom of the string.
    • Take the second band and hook it on to the third band. Don't worry if the bead pops out- you can rectify this at the end.
  5. 5
    Repeat until you reach the end of the bracelet and it is long enough to go around your wrist. Remember, put each band on your middle finger and your index finger, thread the string through, slide the bead on the string, hook the band onto the bead, then put another band on your fingers. Continue doing this to the end.[2]
    • Remember, don't let go of the string when a bead is on it or the bead will slide off of the end.
    • Get plenty of bands and beads- you don't want to run out halfway through.
  6. 6
    At the end, put a last band on but don't put a bead on. Then hook the end to the 'S' clip. Poke the beads that have popped out into the bands if you want, but it looks good either way. Cut the loose end off the string. Your loom band with beads is now finished.
  7. Advertisement

Community Q&A

  • Question
    How do you make a name in loom beads?
    Poohbearfanatic
    Poohbearfanatic
    Community Answer
    Buy an Alpha loom. It's like a rainbow loom, but it's for making loom bracelets with names.
  • Question
    Can you make this without the string?
    Linnie
    Linnie
    Top Answerer
    Yes. Instead of placing beads on the string, you can squeeze a band through the center of the bead and make the bracelet that way.
Advertisement

Warnings

  • Do not pull the bands off of your fingers at any time whilst you are making it, or you will not be able to recover it.[3]
    ⧼thumbs_response⧽


Advertisement

About This Article

wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 24,457 times.
38 votes - 41%
Co-authors: 7
Updated: September 28, 2019
Views: 24,457
Categories: Loom Bracelets
Advertisement